Adding a schedule to discover hosts consists of completing a set of questions that are broken out into five sections.


Introduced in Sandfly 4.2, the new schedule form can be opened in one of two ways. Either click on the Scheduler > Add New Schedule option in the side bar or the Add Schedule button on the Schedules page. Then enter data into the following fields:


Section 1: Schedule

  • Schedule Type - For a host discovering schedule select the Discover Hosts option.
  • Name - A textual label for the schedule to know what the scan is related to.
  • Timer Lower Limit - The minimum number of minutes to wait before running this schedule again.
  • Timer Upper Limit - The maximum number of minutes to wait before running this schedule again.
  • Restrict Schedule to a Time Window (optional) - If enabled, runs the schedule only within certain hours.
    • Schedule Begin Hour - The beginning hour, in UTC, that a schedule can initiate a scan.
    • Schedule End Hour - The ending hour, in UTC, that a schedule can initiate a scan.


Adding a Discover Hosts Schedule - Section 1

Adding a Discover Hosts Schedule - Section 1


The remaining sections of this form are the same as when adding a host. Detailed descriptions of each field can be found in the Adding Hosts page, therefore only field summaries are included on this page.


Section 2: Host Details

  • Type - The type of list that will be entered. Only one of the two options can be selected.
    • IP / Hostname List - A list of IP addresses or hostnames. 
    • IP Netblock List - Up to a class B network in CIDR notation (e.g. 192.168.1.0/24).
  • SSH Port - SSH port to use for authentication.
  • Tags (optional) - Host tags that will be applied to every new host registered during this scan.


NOTE: Netblock Scanning is Limited to Class B

Sandfly can accept up to a Class B network at a time (65,535 hosts). If you need to scan more than this, you will need to enter each net block in as separate entries.



Adding a Discover Hosts Schedule - Section 2

Adding a Discover Hosts Schedule - Section 2


Section 3: Add Credentials

  • Credential - The select the credential that Sandfly will use to login to the list of hosts.


Section 4: Add Jump Host

  • Jump Host (optional) - If jump host(s) are to be used to connect to the listed systems, they are set in this section. At least one jump host must previously have been setup in order to show choices in the drop down box. The order of selection will determine the order of connection.


Section 5: Select Queue

  • Queue - Scanning node queue name to be used by the add hosts. The default queue name is main if you have not enabled this feature on your Sandfly nodes.



Previous
Previous Article:

Next Article:
Next